4 ways to clean your carpets

Basically, carpet cleaning methods could be placed in one of two categories: wet cleaning or dry cleaning. Wet cleaning involves hot water extraction and may include cleaning with an absorbent pad. Dry carpet cleaning includes the use of chemical powders or foams applied by specific machines with counter rotating brushes, pads or cylinders.

1. Wet cleaning
How it works

Also called hot water extraction or steam cleaning, the carpet is initial pre-conditioned using a chemical reagent that liquefies soils and oil-based substances which may well be present within the carpet fibers. Water is heated to a temperature close to its boiling point and pressurized, then injected into the carpet. Following about ten to 15 minutes, the option is extracted with a vacuum.
Need qualified support together with your project?
Get quotes from top-rated pros.

Gets out soiling from deep down inside the carpet.

Makes it possible for the use of higher temperatures, pressures and chemical concentrates.

Permits extended dwell occasions for reaction of cleaning solvents.

Most widely utilized process.

Advisable by carpet producers and industry cleaning authorities and professionals

Fairly extended drying time, but this can be reduced using the use of effective gear by competent technicians.

Pricey equipment generally expected for maximum efficiency.

Reasonably higher cost aspects.

two. Cleaning with an absorbent pad
How it performs

This carpet cleaning method can also be frequently known as bonnet cleaning and is most generally utilized for routine light upkeep. It could also be utilized for frequent carpet cleaning. The carpet is 1st vacuumed, and after that a chemical solution is sprayed on to it having a hand pump or electric sprayer. The remedy is permitted to keep around the carpet for a appropriate dwell or reaction time.

The absorbent pad or bonnet, which looks like a towel, is placed around the drive block of a rotary floor machine and spun over the carpet surface at one hundred to 300 rpm. This action serves to impregnate the carpet fibers with the chemical option after which choose it up with the soils afterward.

Rapid, simple and economical.

Outstanding benefits with lightly soiled carpets.

Only cleans the leading one-third of carpet fibers, incapable of reaching deeper down.

Leaves dirt and chemicals to accumulate at the bottom of your carpet fibers.

three. Dry cleaning with an absorbent compound
How it operates

A powder which has been mixed with specific solvents and cleaning agents is spread over the carpet, after which worked into the carpet fibers with a machine fitted with counter-rotating brushes. The powder absorbs soils in the carpet fibers. Immediately after it’s permitted to set around the carpet for 10 to 15 minutes, it’s vacuumed up.

Pretty uncomplicated method with no particular technical education required.

Pretty rapid drying, it ordinarily only takes about 20 minutes just before the carpet is often back in service.

Powder may be trapped in plush pile carpets and left to make up over time.

Can cause excessive dust build-up in the property.

Unable to clean deep down into the carpet.

4. Dry foam or rotary shampoo approach
How it performs

A cleaning agent is applied to the carpet to assist suspend dirt and debris within the carpet, which can be then whipped into foam and worked into the carpet fibers together with the rotating brushes of a particular machine. Following a brief dwell time, the foam is extracted with a vacuum.

Speedy, easy to apply and low-cost.

Rotating brushes deliver great agitation.

Smaller quantity of moisture makes it possible for rapid drying of carpet.

Unable to attain thorough soil extraction under the surface on the carpet.

Higher temperatures commonly not accomplished.

Excessive wetting feasible with gear malfunction.